Hey Raj,
I ran through the troubleshooting steps as you laid out and the task failed. I set the task to automatically reboot the server if needed, but the server never did reboot. I performed a discovery and inventory after 30 minutes on the server in OME and the two updates (BIOS and NIC firmware) still show as required. The error messages for the update task are below.
Thanks,
Jason
PackageCode 1
PackageFileName C:\DOCUME~1\ADMINI~1\LOCALS~1\Temp\s35g\BIOS_VHP27_WN32_1.11.0.EXE
PackageLog << PACKAGE LOG (SelfExtractable) >>
wer than the currently installed version.
Software application name: BIOS
Package version: 1.11.0
Installed version: 1.9.0
Executing update...
Device: BIOS, Application: BIOS
doDepcheck failed
==============================> Update Result <==========================
Update was not applied
=========================================================================
Exit code = 1 (Failure)
2013-05-22 10:49:11
<< PACKAGE LOG (SelfExtractable) >>
ate Package application started <===============
Command: C:\DOCUME~1\ADMINI~1\LOCALS~1\Temp\s35g\BIOS_VHP27_WN32_1.11.0.EXE
Date: 2013-05-22 10:49:11
=========================================================================
PackageReleaseId Not Available
PackageState complete
PackageStatus 5
PackageCode 1
PackageFileName C:\DOCUME~1\ADMINI~1\LOCALS~1\Temp\s35g\Network_Firmware_H15FK_WN_7.2.20_A00.EXE
PackageLog << PACKAGE LOG (SelfExtractable) >>
=======================> Update Result <==========================
Update was not applied
=========================================================================
Exit code = 1 (Failure)
2013-05-22 10:47:46
<< PACKAGE LOG (SelfExtractable) >>
==========
PackageReleaseId Not Available
PackageState complete
PackageStatus 5
TotalStatus One or more Update Packages failed during execution, but the update continued running to the end.
TotalStatusMessage Software update complete.